The SoundCam 2.0

The SoundCam 2.0 is a fully portable, easy-to-use point-and-measure system with a built-in display and battery. It uses the common SoundCam software that runs on all SoundCam systems which can also be run remotely on a Windows PC (safety situations).

Noise Inspector can also be used with the SoundCam 2.0 for data collection and advanced post-processing analysis including HD beamforming.

For advanced post-processing, analysis, and HD beamforming consider using the optional Noise Inspector software.

• Maintenance & Servicing

• Health & Safety

• NVH, Squeak & Rattle

• Product Development

• Noise Localization / Sound Localization

• Building Acoustics

 – SoundCam Software –

The SoundCam software is a point-and-measure real-time software.  It allows you to fine-tune your measurements and then store up to 60s of measurement data on a rolling basis so when you see what you want, then store it.  You can also take pictures and create videos.  Event-based detection and documentation are available using sound-level or spectrum-based triggers that will automatically save the measurement and pictures.  Data stored by the SoundCam software is pre-processed beamforming data that can be replayed with different level scaling.  For more advanced after-the-fact processing you will need the Noise Inspector software.

– Noise Inspector –

Noise Inspector is a data collection and analysis software that operates on Windows PC.  Unlike the SoundCam software which is primarily designed for real-time analysis and storing beamformed data, Noise Inspector stores the entire data stream, from all microphones, which then can be processed after the fact.  Noise inspector is a better option when:

• You have limited time to collect data or only have a single opportunity at collecting data
• Desire or require to process and analyze data later time
• Need to analyze a complex situation
• Require High-Definition or use of different beamforming algorithms.